Manufacture
- Monarch-Stamco
- new 1997
- upgraded 2008
Material
- All common Aluminum alloys and clad products
- Full hard to dead soft temper range
Strip Width
- 24 - 62" (entry)
- 60 - 2" (exit)
Strip Thickness
- .0065 - .060"
Entry Coil Size
- ID - 16, 20, 24"
- OD - 100"
- Weight - 40,000 lbs
- Unwinding = overwind only
Exit Coil Size
- Min cut = 2”
- ID - 16, 20"
- OD - 36" max for 2-3" wide cuts / 40" max for 3-6" wide cuts / 48" max for 6-12" wide cuts / 75" max above 12" wide cuts
- Weight - 25,000 lbs max (each recoiler)
- Winding: Over and under wind capable (in any combination)
Slitter Capabilities
- Arbor Size - 6.50" diameter
- Maximum incoming width: 62”
- Minimum incoming width: 24”
- Maximum trim width: 60”
- Minimum slit width: 2”
- Cuts: .0065”-.030” (8 cuts maximum) / .031” - .060” (6 cuts maximum)
- Maximum side trim width: none as trim can be wound to winder
- Minimum side trim width: .50”
Line Speeds
- Low Gear – 500 fpm maximum
- High Gear – 1000 fpm maximum
Hand of Line
- Right to Left
Control System
- GE 90-30 PLC
Drives
- Siemens Simoreg
Line Description
- Single Uncoiler
- Dual Recoilers
- Vertical Pass Slitting
- Light/Medium Gauge aluminum
Basic Line Equipment:
- Unwind Reel Drive – 100 HP DC motor driven, dual speed gearbox
- Unwind Edge Guide: North American
- Unwind Pinch Roll
- Entry Shear
- (2) Stamco #6 Vertical Pass slitter heads (one in-line and one for next set-up;
exchange heads with overhead crane)
- Slitter Drive – 30 HP DC motor driven, single speed gearbox
- Trim Pull Rolls: Pneumatically driven
- Scrap Baller: 25 HP AC motor driven, single speed gearbox
- Recoiler Drives – 100 HP DC motor driven, dual speed gearboxes
Sold "as is, where is" EXW dismantled at plant, USA.
Photos are a combination of when the line was installed and in it's current dismantled state.
The line was properly dismantled by a rigging contractor!
