18" X 26" WATERBURY FARREL Hot/Cold Reversing Rolling Mill, 2-HI for Flat Sheet and Bar (14344)
| Type | 2 HI HOT/COLD ROLLING MILL | 2 HI HOT/COLD ROLLING MILL |
18" X 26" WATERBURY FARREL 2 HI ROLLING MILL
Stock # 14344
MANUFACTURER: WATERBURY FARREL CORPORATION (USA)
TYPE: 2 HI REVERSING ROLLING MILL FOR FLAT SHEET OR ROD/BAR
ROLL SIZE: 18" (457MM) DIAMETER X 26" (660MM) WIDTH
DRIVE MOTOR: 300 HP, 600/1500 RPM, 1000 AMPS, 250 VOLT TOSHIBA D.C.
GEARBOX: PHILADELPHIA MFG. (USA) WITH 32.5 TO 1 GEAR RATIO
ROLLING SPEED: 0 - 200 FPM (0 - 60 M/MIN)
SCREWDOWNS: MOTORIZED WITH TWO 7-1/2 HP, 540/1620 A.C. MOTORS
ROLL BEARINGS: ROLLER
PASS LINE HEIGHT: 49" (1244 MM)
HOUSING CROSS SECTION: 16" (406 MM) X 13" (330 MM)
MAXIMUM ROLL OPENING: 7.5" (190 MM)
ELECTRICAL CONTROLS:
-MANUFACTURER: SABINA ELECTRICAL ENGINEERS (USA)
-UPGRADED AND INSTALLED IN 2006
-TYPE: SCR THYRISTOR DRIVE
-INPUT: 230 VOLTS, 1200 AMPS, UP TO 400 HP, 3 PH, 60 HZ.
-OUTPUT ARM VOLTS: 250, 130 AMPS
-OUTPUT FIELD VOLTS: 250, 13.5 AMPS
MILL IS INSTALLED AND FULLY OPERATIONAL LOCATED IN USA
INCLUDES:
-THREE SETS OF ROD/BAR ROLLS
-ONE SET OF FLAT SHEET/STRIP ROLLS
-ENTRY DRIVEN ROLLER TABLE 12.5 FT. (3.8 M)
-EXIT DRIVEN ROLLER TABLE (12.5 FT. (3.8 M)
-DRAWINGS (APPROX. 100)
MILL IS AVAILABLE FOR INSPECTION WITH APPOINTMENT
**Temporary Specifications Subject to Revisions**
**PRICE QUOTED AS IS WHERE IS SUBJECT TO PRIOR SALE**
**ALL SPECIFICATIONS ARE SUBJECT TO BUYERS VERIFICATION**
