Your Cart
You don't have any items in your cart.

USED A & A Sheet Metal Securall

USD $75,000.00
1 available
Overview
Manufacturer:
A & A Sheet Metal
Model:
Securall
Status:
For Sale
Description

Beautiful Used Unit
Can be shipped immediately to avoid 52 week lead time from manufacturer
MSRP $150,000, buying used will save thousands!
Can be used to store various items such as Li-Ion batteries, paint, solvent, etc.
Custom Building: 8'4"H x 50'W x 8'D
-4 Hour Fire Rated, -Explosion Relief Panels, -Sump Capacity: 1486 Gallons, Estimated Weight: 40,198 Total Pounds
-Fire Rated Walls are Intertek tested and FM approved for 4 Hours. -Fire Rated Roof is Intertek tested and FM Approved for 3 Hours. Explosion Relief Panel Upgrade for Custom Building Explosion-Proof Interior Light w/Switch
Additional Explosion-Proof Interior Light
Explosion-Proof Fan Forced Heater-25,600 Btu -With Thermostat Explosion-Proof Air Condtioner-19,500 Btu -With Color Coded Thermostat
Insulation Walls and Ceiling
Dry Chemical Fire Suppression System
Dry Chemical Fire Suppression System Alarm-Bell
Explosion-Proof Exhaust System-388 CFM w/Indicator Light Break Glass Switch for Explosion-Proof Exhaust System
10 x Adjustable Vents with Insulated Cover-18 x 18 DESIGN CERTIFICATION STATE APPROVAL for VA.
NOTE: Building may require State Approval.
Please check with your Local Authorities (ie Fire Marshall) to determine if State Approval and/or State Seal are required.
*Standard options are located on left side of building.
Building has double wall, Welded construction, 3” airspace throughout.
* Exterior walls are 12-gauge Galvannealed steel. Interior walls 20-gauge cold roll.
* One 60”W x 80”H,Double Door with a UL classified Commercial grade keyed lock set.

* 12 Gauge steel sump.
* Heavy Gauge forklift channels with open-end construction.
* Bolt-down plates (4) with 7/8” diameter holes for wind and seismic bracing. * Multiple static grounding connections.
* Inlet vents for natural ventilation with fire dampers if a fire rated building.
* Load Center is 120/240 Volt Single-Phase NEMA 3R Rated.
* Explosion relief panels located in the rear wall of the building.
* Hazard labeling (DOT Placard Holder, NFPA 704 rating signs).
* Finish is a two-part chemical resistant aliphatic polyurethane.
* Complies to NFPA Code 30.
* Building Factory Mutual approved, and UL listed accessories.

Similar Listings

Similar Categories

Similar Brands