| Chuck Size | 60" | 1,524 mm |
| Horz/Vert | Vert | Vert |
CHUCK: (Electro-Magnetic)
Diameter 60" (1,524mm)
R.P.M Infinitely Variable thru 28
Actual Swing- 66"
GREATEST SWING INSIDE WATER PAN,
73½" (1,866.9mm)
GRINDING WHEEL: Segmental Type,
Diameter 32" (812.8mm)
GRINDING WHEEL ASSEMBLY:
Vertical Movement 30" (762mm)
By (Handwheel and Power)
WHEEL HEAD FEED RATE: Variable
Automatic 0.005" thru 165" per/min.
(0.127mm thru 4,191 per/mm)
Pre-determined 0.001" thru 240" per/min.
(0..0254mm thru 6,096 per/mm)
MOTOR DRIVES: wired 460 volts 3-phase
Stone 125 hp (91.94kw) 230/460 volts
Chuck Rotation Hydraulic Drive 5 hp.
(3.7kw) 230/460 volts
Carriage Head Vertical Feed Up/Down 3 hp.
(2.2kw) 230/460 volts
Motor Cooling Fan ¾ hp.
(0.55kw) 230/460 volts
Coolant Pump 1½ hp.
(1.103kw) 230/460 volts
CONTROLS: Controls Wired 115 volts
Master Start/Stop Buttons,
Spindle Start/Stop Buttons,
Table Start/Stop Buttons,
Down Head Feed Start/Stop Buttons,
Head Up/Down Buttons,
Carriage In/Out Buttons,
Coolant Off/On Switch,
Head Flat Tilt Switch,
Variable Feed Rate Dial,
Table Traverse handwheel
Approx Dimensions- 8' x 17' x 171
Coolant Tank Dimensions- 4' x 10'
60" Chuck W/ 6" chuck life left,
36" Stone Cutting Head,
Head Quick Tilt,
Motor Percent Load Meter,
Wheel Dresser (Manual),
Neutrofier Remote Control,
Coolant Pump & Tank,
Point of Operation Enclosure Door,
COMPLETE FACTORY SAFETY GUARDS,
Master Start/Stop Buttons,
Spindle Start/Stop Buttons,
Table Start/Stop Buttons,
Down Head Feed Start/Stop Buttons,
Head Up/Down Buttons,
Carriage In/Out Buttons,
Coolant Off/On Switch,
Head Flat Tilt Switch,
Variable Feed Rate Dial,
Table Traverse handwheel,
