36" X 120" LEBLOND HOLLOW SPINDLE LATHE, 9.25" Spindle Bore, Front & Rear Chucks, 10-362 RPM,
Swing: 36"
Distance Between Centers: 120"
Bed Width: 24"
Overall Bed Length: 144"
(18) Spindle Speeds: 10 – 362 RPM
(60) Feeds: .0045 – .269 Thousandths per Rev
(60) Inch Threads: 1 – 60 Threads Per Inch
Hole Through Spindle: 9-1/4"
Spindle Nose: Uses Flat Back Chucks with Two Different Bolt Hole Diameters for the 3 Jaw and 4 Jaw Chucks. This Does Not Correspond to any Common Design like Long Taper, Short Taper or Camlock.
Taper in Tailstock: #5 Morse
Tailstock Travel: 20"
(2) 21" 3 Jaw Chucks with 9-1/4" Holes
(2) 21" 4 Jaw Chucks with 9-1/4" Holes (Cushman Brand)
(1) 25" Face Plate
11" Hold Diameter Bronze Bushing Type Steady Rest
Quick Change Tool Post (No Holders)
2-Speed Tailstock with Thru Hole
Taper Attachment (Bed Clamp is Missing)
Rapid Traverse to Carriage and Cross Slide
Hard Replaceable Bed Ways in Good Condition
(2) Roll Out Removeable Chip Pans
Independent Floor Mounted Main Spindle Motor
20 HP Main Motor
Wired for 3 Phase, 60 Cycle, 220/440 Volts
Currently Wired for 440 Volts
***We strongly encourage personal inspection of all pieces of used equipment***
***All Price, Location and Specifications Subject to Change without Notice***
