Lees Bradner Model SH 8 x 54 Horizontal Spline hobbing machine. This machine is equipped with a large hole through the work spindle of 6" to allow the cutting of long splines securely clamped or cut between centers . See the machine specs below as this machine is a must for any shop cutting long splines.
| Max Workpiece Diameter | 8" | 203.2 mm |
| Horz/Vert | Horz | Horz |
| Weight | 8500 lbs | 8500 lbs |
Lees Bradner Horizontal Spline hobbing machine
Model SH 8 x 54 s/n SH 173
Excellent condition
Machine was designed for the Manufacture of large splines and shafts between centers
up to 54" in diameter. It also supports a hole through the work spindle of 6" to
allow for longer shafts. the tail center can also be removed and a steady added to
increase the length of parts held
Machine specs are as follows:
Max Diameter Hobbing capacity 8.75"
Bore through the work spindle 6.44"
Max Face width of cut between centers 54"
Max swing over ways 24"
Max Swing over Carriage 12"
Max Rated DP 3.5 DP
Max Helix angle 45 degree
Max hob Length 5"
Max hob Diameter 4"
Max hob speeds 96-214 RPM
Max Hob shift 2"
Main drive 15HP
Machine Machine weight 9,000 lbs
Machine dimensions 11' long x 6.5' deep x 5' tall
Machine is equipped with the following"
1-1/4" diameter hob arbor
through hole fixture with collect clamping
push button panel
operator pendant control
Rapid traverse
good assortment of change gears
Misc tooling , drive dogs, etc as photographed
Note : no hobs are being sold with the machine
Contact us today to set up an under power inspection of this machine. We welcome
your visit to see this and other machines in excellent condition. visit
WWW.PiselliEnt.com or contact Rich@piselliEnt.com to discuss this machine
or request a quotation. thank you !
