USED 1997 KINGSTON HJ-1100

17" x 43" ISO 9001 Certified manufacturer
Headstock is made of high tensile cast iron provides rigidity and durability
Spindle is made of medium carbon steel (S45C), hardened by high frequency heat treatment and then precisely ground
Spindle is supported by three high precision bearings to assure accuracy and rigidity
Headstock gears are made of chromium molybdenum steel (SCM-21), treated by cementation then precisely ground to provide smooth and quite running
Forced lubrication system is employed for headstock to ensure accuracy and operation life
Unique designed gear box is driven by timing belt, offers a comprehensive range of inch and metric threads without use of change gears and provides a wide range of feet rate selection
All gears in the gear box are made of SCM-4 steel and hardened, gears are running quietly
Output shaft with safety pin to protect gear box from damage
Gear box is oil bathed
Hardened and ground large cross slide ways provide double wear-resistance
Oil bathed and hardened cross slide screw is equipped with backlash adjustment feed nut to maintain accuracy
Tool post designed with adjustable taper fit and equipped with thrust bearing to provide lasting accuracy and easy lock
Manual and automatic lubrication system is equipped on apron, will keep cross slide ways and bedways clean and lubricated to assure durability and accuracy, the forced lubrication can be adjusted
Automatic feeding and threading are fully interlocked to prevent simultaneous engagement of feeds and threads
Apron is equipped with an overload protection device to avoid machine damage
Hardened and ground large tailstock quill with inch and metric scale graduated is made of chromium molybdenum steel (SCM-21), Rockwell® HRC60 hardness
All controls within easy reach
Starting lever with safety device
Emergency foot operated braking system

Kingston HJ-1100 17" x 43" Engine Lathe

Swing Over Bed (In.) 17
Swing Over Cross Slide (In.) 10-9/16
Swing in Gap (In.) 24
Distance Between Centers (In.) 43.5
Width of Bed (In.) 11.75
Gap Width in Front of Face Plate (In.) 5-7/8
Height of Center from Leg Bottom (In.) 42-3/8
Spindle Through Bore (In.) 2-1/4
Taper of Spindle Bore and Center MT-6 | MT-4
Type of Spindle Nose D1-6
Number of Spindle Speeds 12
Range of Spindle Speed (RPM) 35 - 2,000
Number of Feed Changes 16
Range of Feeds per Revolution - Longitudinal (In.) .0012 - .039
Range of Feeds per Revolution - Cross (In.) .0004 - .0117
Diameter and Pitch of Leadscrew (Diameter | TPI)
1.38 | 4
Number of Inch Threads
44
Range of Inch Thread (TPI) 2 - 72
Number of Metric Threads 39
Range of Metric Thread (mm)
.2 - 14
Maximum Travel of Compound (In.) 5-7/8
Maximum Travel of Cross Slide (In.) 10.4
Tailstock Quill Travel (In.) 5-7/8
Tailstock Quill Diameter (In.) 2-3/8
Taper in Tailstock Quill MT-4
Main Motor (HP | KW)
7-1/2 | 5.59
230V/460V/3 Phase/60 Hz.,
Prewired 230V
Coolant Pump Motor (HP | W)
1/8 | 93.21
Machine Assembled Dimensions (L x W x H/In.) 87 x 41 x 47
Machine Floor Space Dimensions (L x W x H/In.) 98 x 41 x 47
Machine Weight (Lbs.) 3,520